1.0
INTRODUCTION
This manual will serve as a guide to subject matter
experts or curriculum specialists who is responsible for the development of the
Course of Study for a specified program under the Department of Skills
Development (DSD), Ministry of Human Resource Malaysia
This manual will provide curriculum specialists a general
yet comprehensive guideline and expected components, format and layout of a
Course of Study Package.
The National Occupational Skills Standards (NOSS)
developed by the DSD will be used as the basis for developing the syllabus or
content of the Course of Study.
This manual together with the NOSS will be the main
official reference to be used in the development of a Course of Study by
curriculum specialists; so that the Course of Study developed will follow the
general guidelines and standards expected by the DSD, being the authority of
the Malaysia
2.0 Purpose/Usage
A CoS Package will provide module developers or trainers
with a guide and direction when preparing training materials or Written
Instructional Materials (WIM) for a particular program.
i.
The
CoS Package will contain information pertaining the job performance and
competency requirements of a particular skill.
ii.
The CoS Package will contain information on
the training programs to be conducted and the sequence of the learning, for a
learner to achieve the skill competency required.
iii.
The CoS Package will contain
a set of CoS which provides a comprehensive description on the knowledge to be
delivered for each training module.
iv.
Each individual CoS will contain information pertaining to the mode and
scope of coverage of knowledge to be delivered and the tasks to be performed.
v.
The CoS
will assist trainers in course planning, training implementation, evaluation
and monitoring the effectiveness of course delivery.
vi.
The CoS
will provide guidelines to carry out assessment for understanding of knowledge
delivered.
vii.
The CoS
will provide guidelines to conduct assessment to determine competency
achievement expected of trainees.
1. MODULES
|
M01
|
MOULD DRAWING INTERPRETATION
|
|
|
M02
|
MOULD MATERIAL PREPARATION
|
|
|
M03
|
MOULD PART FABRICATION
|
|
|
M04
|
MOULD PART MEASUREMENT
|
|
|
M05
|
MOULD
ASSEMBLY AND TESTING
|
|
|
M06
|
TRY OUT AND TROUBLESHOOT TWO PLATE MOULD
     |
|
TRAINING PATHWAY
No comments:
Post a Comment